VIRATA ATMOS Console Manual de usuario descargar pdf (Pagina 21)

EMEA CSO 0013 USR8550 – Console commands 23/04/02 Page 21/58

that is expected to be used for packets to the remote host. This interface can change over the

lifetime of an association; in particular, for a UDP

association not bound to a specific remote host it may change each time a packet is sent to a

different destination. (In other cases it will normally change only as a result of routing

changes.) The “files” command is “hidden”, not shown by “ip help”.

Example:

mymachine> ip files

1: rw+ ether 192.168.2.1 TCP port telnet (23) Established to 192.168.2.2

port 1071 1 rx requests

2: rw+ ether <noaddr> UDP port snmp (161) 3 rx requests

3: rw+ <unset> <noaddr> UDP port tftp (69) 4 rx requests

4: rw+ <unset> <noaddr> UDP port router (520) 2 rx requests

5: w vlane <noaddr> UDP port router (520)

6: rw+ <unset> <noaddr> UDP port 2050 4 rx requests

7: rw+ <unset> <noaddr> UDP port 2051 4 rx requests

8: rw+ <unset> <noaddr> UDP port 2052 4 rx requests

9: rw+ <unset> <noaddr> UDP port 2053 4 rx requests

mymachine> ip files 3

3: rw+ <unset> <noaddr> UDP port tftp (69) 4 rx requests

//ip/TYPE=UDP/LPORT=69/TIMEOUT_CONX=1000/TIMEOUT_LISTEN=0/TIMEOUT_IDLE=0/

RETRY_CONX=2/TOS=routine/DELAY=normal/THROUGHPUT=normal/RELIABILITY=normal/BUFFERRX=off/B

UFFER_TXSIZE=-1/BUFFER_RXSIZE=-

1/FRAGMENT=on/TTL=60/OPTIONS=off/CHECKSUM=on/TIMEOUT_USER=540000

flush

Syntax:

flush <assoc>

Description:

Given an association number (see “files” command) that corresponds to a TCP association, this

does a TCP “push” (see RFC 793), which, roughly speaking, causes the data sent s o far to be

delivered as quickly as possible to the recipient, without waiting to be buffered with

subsequent data. The “flush” command is “hidden”, not shown by “ip help”; it is of little or no

use.

See also:

files

get

Syntax:

get <file>

Description:

Reads and executes commands from a file. The commands in the file are in the same format

as those documented in this chapter, with no “ip” prefix. They can contain comments,

introduced by the “#” character. The “get” command is “hidden”, not shown by “ip help”.

Example:

mymachine> ip get //isfs/cmdfile

help

Syntax:

help

help <cmd>

help all

Description:

Displays a summary of available commands, more detailed information on a particular

command, or more detailed information on all commands. (As described in section 7.1, some

commands are “hidden” and are not displayed by “help” or “help all”; help is still available on

these using the “help <cmd>” form if one knows the name of the command.)

Example:

mymachine> ip help

Commands are:

? arp config device

disable enable help ipatm

norelay ping relay restart

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 58 59

Comentarios a estos manuales

Sin comentarios

VIRATA ATMOS Console Manual de usuario Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Redes VIRATA ATMOS Console